For New Masonry Surfaces

• Step 1: Primer (1 Coat) – Dry min. 8 hrs
• Step 2: Wall Putty – Dry 6–8 hrs
• Step 3: Primer (1 Coat) – Dry 8 hrs
• Step 4: Finish Synthetic Enamel (2 Coats) – Dry min. 8 hrs between coats

For Metal Surfaces

• Step 1: Primer (1 Coat) – Dry min. 8 hrs
• Step 2: Putty / Knifing Paste – Dry & Scuff
• Step 3: Primer (1 Coat) – Dry 8 hrs
• Step 4: Finish Synthetic Enamel (2 Coats)

For Wooden Surfaces

• Step 1: Primer (1 Coat) – Dry min. 8 hrs
• Step 2: Wall Putty – Dry 6–8 hrs & Scuff
• Step 3: Primer (1 Coat) – Dry 8 hrs
• Step 4: Finish Synthetic Enamel (2 Coats)

• Surface must be clean, dry and free from dust, grease & wax
• Remove loose or poorly adhering material using abrasive paper
• Treat fungus-affected areas with fungicidal solution
• Apply suitable primer followed by putty if required
• Finish with two coats of Synthetic Enamel

• Do not apply below -10°C or above 60°C
• Do not apply when humidity exceeds 80%
• Flammable – keep away from sparks and open flames
• Causes eye and skin irritation
• Wear gloves, goggles and protective clothing
• Ensure proper ventilation during application
• Store in cool, well-ventilated area
• Keep out of reach of children